Difference between revisions of "Arduino Target for Simulink"

From Matt Bilsky

(Below is a video showing the install process performed in Simulink 2011a)
Line 1: Line 1:
== Installing the Arduino Package ==
+
== Installing the Arduino Package in Simulink 2011 ==
  
 
=== To install the Arduino Target for Simulink: ===
 
=== To install the Arduino Target for Simulink: ===

Revision as of 16:26, 27 April 2012

Installing the Arduino Package in Simulink 2011

To install the Arduino Target for Simulink:

  1. Download the package located here: http://www.mathworks.com/matlabcentral/fileexchange/30277
  2. Extract the zip file to an easy to find location (i.e. C:/arduinoTarget)
  3. Follow the installation instruction located at C:/arduinoTarget/README.txt

Note the following changes to the instructions from MathWorks:

  • We are going to use the Arduino IDE version 23 which may be downloaded here: http://arduino.cc/en/Main/Software. Just extract the archive to an easy to located directory (i.e. your desktop)
  • As stated in the README file, PIL (processor in the loop) mode is only supported in matlab 2011b or later. This guide was written using 2011a.


Below is a video showing the install process performed in Simulink 2011a

(Set playback to 720p for a clearer picture)