Arduino Target for Simulink

From Matt Bilsky

Revision as of 01:01, 28 December 2011 by Matt Bilsky (talk | contribs) (Installing the Arduino Package)

Installing the Arduino Package

To install the Arduino Target for Simulink:

  1. Download the package located here:
  2. Extract the zip file to an easy to find location (i.e. C:/arduinoTarget)
  3. Follow the installation instruction located at C:/arduinoTarget/README.txt

Note the following changes

  • We are going to use the Arduino IDE version 23 which may be downloaded here: Just extract the archive to an easy to located directory (i.e. your desktop)
  • As stated in the README file, PIL (processor in the loop) mode is only supported in matlab 2011b or later. This guide was written using 2011a.